I have been having fun getting off the ground with the starter kit. Unfortunately I have a mix of overconfidence and inability and plugged higher voltage battery and I believe (at best) blew a resistor/fuse or (at worst) fried something less replaceable. Id like to learn to chase down the broken component on the PCB and desolder it if possible. Can anyone push me in the right direction?
Oh no! what are the symptoms? Are you still able to flash the device over ESPHome?
If you have blown up something on the board, unfortunately the most likely device to die is the ESP32 chip itself as opposed to the passive devices.
What kind of battery did you plug in?
sorry for the delay, it was a 7.4 V 2200mAh battery. I managed to get it up and running again. My only issue is that I don’t know how I was able to! I didn’t do anything different but now its working.